online@akgaya.com +99312 75 45 57

SATEN

FINISHING PLASTER

SATEN, with its high adherence, is a finishing plaster used as an undercoat for all types of painting.


SATEN can be applied to SIVA and gypsumboard surfaces.

Its long workability time enables an easy application with a low waste rate.


Special additives in its formulation delay the absorption of SATEN mortar’s water by the substrate.

SATEN’s paste-like texture makes it easy to apply.


As it is a breathable material, by regulating humidity SATEN leads to a healthier environment.

FINISHING PLASTER

METHOD OF APPLICATION

Before application, clean off all dust and dirt as it may cause poor bonding.

Pour water into a clean bowl. Add SATEN slowly until it covers the water surface. Wait for a few minutes, then mix the mortar until a homogeneous mixture is achieved. After mixing, the mortar is ready to use. The mortar in the bowl can be used for approximately 1 hour.

To apply, use a plaster trowel and a steel spatula.

Scrape off any residues after they set. Clean your tools after use.

RECOMMENDATIONS

Never mix SATEN with any other product or material.

Use a low-speed mechanical mixer.

Do not add water or plaster to the mortar after mixing.

Do not use SATEN in temperatures below +5°C.

FINISHING PLASTER

STORAGE CONDITIONS

Bags should be stored in a dry place and should not be stacked more than 20 bags high.

Do not allow bags to be in contact with the ground or with moisture.

SATEN should be used within 6 months of the manufacturing date. Poor storage conditions or exceeding the shelf-life may cause the physical properties of SATEN to deteriorate.

TECHNICAL SPECIFICATION

Water/Plaster ratio ........ 6.5–7 L of water to 10 kg SATEN

Setting time starts ...................................... > 20 minutes

Workability ...................................................... 60 minutes

Final setting time ......................................... 130 minutes

Coverage ................... 1 kg/m2 for each 1 mm thickness

Compressive strength (min.) ................ 35 kgf/cm2 (4x4 block)

Pass 160 micron sieve (min.) ........................ %99,5

Pass 45 micron sieve (min.) ............................. %80

Bulk density (powder) .............................. 750-800 kg/m3

Fire classification ..................................................... A1

STANDARD

Reference standard ................................ TDS-31377-2008

Type ....... C6/20/12 Thin Coat Plaster, Finishing product

PACKAGING

Type ................................. Polypropylene laminated bags

Net weight ........................................................... 30 kg±%1


PROTECT FROM MOISTURE

FIRE RESISTANCE: A1

SOUND INSULATION: NPD

THERMAL INSULATION: NPD

MADE IN TURKMENISTAN

EASY TO USE

BASE TEMPERATURE

FOR INTERIOR USE

USAGE TIME 30 MINUTES

THICKNESS OF APPLICATION 5-40 MM.